Stitched Label Box

I actually have some cards to share with you today!  I had Stamp Club Tuesday and even though it was a small group, we had fun and make some cute projects.

First off - although we did this one last - was the Stitched Label Box.  I found this on Brenda Quintana's blog and love it so much.  I was hoping not to overwhelm my gals and had all the pieces die cut for them which helped a lot except when I gave them the wrong measurements for scoring!  Luckily, we discovered it early enough that we didn't waste too much paper.  You can die cut all the pieces for the box out of one piece of cardstock if you are mindful about placing the dies on the paper.  You will also need 2 pieces 10 3/8" long.  I used Whisper White Thick Card Stock for my box and the Bird Ballard Designer Paper.  You only need a 1/2" strip of DSP (10 3/8" long) so look through your stash  and pick something that you have just a strip of.  Some of the boxes we made today used the Magnolia Lane Designer Paper.  The stamping on the top of the box is from Good Morning Magnolia.

I hope you will try and make this cute box - it really is not hard!!

STITCHED LABEL BOX

2 ea. 2^nd largest Stitched Label Die (LABEL #1)

2 ea. 3^rd largest Stitched Label Die (LABEL #2)

1 of the 2^nd smallest Die  (LABEL #3)

Thick Card Stock

(1) 10 1/8” x 2” (BOX BOTTOM)

(1) 10 3/8” x 2” (BOX TOP)

Designer Paper – 10 3/8” x 1/2”

BOX TOP LID (w/Designer Paper)

Cut 10 3/8” x 2” piece of Thick Whisper White Card Stock

Adhere a 10 3/8” x ½” Designer Series Paper strip.

With Designer Paper on left, score down the 10 3/8” strip at 1 5/8” (on short side)

Turn ¼ turn to right (the scored line you just did should be at the bottom & the DSP at the top)

On long side, score at:  2 ¾” 3 7/8”, 5”, 7 ¾”, 8 7/8” and 10” 

Notch at each fold.

Adhere the piece end to end.

Adhere Tombow glue to notches

Attach the 3^rd largest Label Die (Label #2) to box lining up both long sides w/label die piece & press down to adhere.

Attach the largest Label Die (#1) to bottom, centering it.

BOX BOTTOM

Cut 10 1/8” x 2” piece of Thick Whisper White card stock.

On short side, side @ 1 5/8” mark.

On long side, score at 2 5/8”, 3 ¾”, 4 7/8”, 7 ½”, 8 5/8”, 9 ¾”

Fold your score lines & notch (V) at each score line.

Adhere the piece end to end like you did for the lid.

Put the box top over top of the box bottom to hold the shape.

Adhere Tombow Glue to tabs & adhere the largest Label die (#1)

Now stamp on Lable #2 & Label #3, color & adhere to Box Lid

You can find this video at Qbee’s Quest website